Advertisement
INTEGRA/-S/-G/-GS User Manual
Status mode
Press
button.
Modify mode
1) Name – Indicates whether the egress rate is enabled or disabled on a particular port
(status mode); allows enabling/disabling egress rate on a particular port (modify
mode).
2) CIR (Mbps) – Indicates configured rate CIR (Committed Information Rate) on a
particular VLAN rate item in Mbps (status mode); allows setting rate CIR on a
particular VLAN rate item in Mbps (modify mode).
3) CBS (kB) – Indicates configured rate CBS (Committed Burst Size) on a particular
VLAN rate item in kB (status mode); allows setting rate CBS on a particular VLAN rate
item in kB (modify mode).
4) Add / Delete – Press "Add" to add entered VLAN rate or press the red cross (
delete this entry;
5) By pressing „Execute configuration", changes made to the corresponding section
apply only to the local side Integra/Integra-S/Integra-G/Integra-GS. If „Rollback on" is
selected, the configuration will be reverted in case erroneous configuration changes
are applied.
CLI commands
(Chapter 4: COMMAND LINE
network vlan show rates
network vlan set rate
{add|delete} <name> cir
<1000...1000000kbps> cbs
<32...671kB>
SAF Tehnika JSC
INTERFACE)
Use to show created rate profiles.
Use to create new or delete existing rate configuration
profiles. Please refer to Chapter Networking → Ethernet →
VLAN to apply the created rate profile to a VLAN ID.
WEB GUI
×
) to
60
Advertisement
