Advertisement
INTEGRA/-S/-G/-GS User Manual
ACM (Adaptive Coding and Modulation)
modulation change according to MSE value. Modulation indicates maximum
modulation, while the minimum is 4QAM.
In case the current Tx power value is above the maximum value for any of the
modulations, the maximum value will be indicated.
14)
By pressing „Execute configuration", changes made to the corresponding section
apply only to the local side Integra/Integra-S/Integra-G/Integra-GS. If „Rollback on" is
selected, the configuration will be reverted in case erroneous configuration changes
are applied.
Pressing „Execute for both" applies changes made to the corresponding section both
for local and remote side
CLI commands
(Chapter 4: COMMAND LINE
radio [status]
radio power <Tx power>
radio frequency <frequency>
radio rssi-led {disable | enable
[mode {1|2|3}]}
radio rssi-led enable mode
{1|2|3} polarization <seconds>
radio tx-mute {<time>|disable}
radio factory
radio upgrade <firmware>
radio version
radio atpc [status]
radio atpc state
{enable|disable}
radio atpc delay <1..5>
radio atpc rx_level <-75..-43> <-
72..-40>
modem configuration set
<bandwidth> <min_mod>
<max_mod>
SAF Tehnika JSC
for further details) enables adaptive
Integra/Integra-S/Integra-G/Integra-GS
INTERFACE)
Use to show radio status.
Use to set Tx power in dBm.
Use to set Tx frequency in kHz.
Use to enable or disable RSSI LED operation.
Use to enable the red RSSI LED's operation for n seconds.
Its main purpose is an indication of polarization alignment
accuracy +/- 3deg. Functionality may not be available in
older HW revisions.
Use to mute the transmitter to a specific time in seconds
or unmute.
Use to reset radio settings to factory defaults – Tx power
will be disabled and frequencies set to factory defaults.
Use to upgrade the radio firmware version. The firmware
file must be located in the FTP directory.
Use to check the radio software version
Use to check the status of ATPC (Automatic Transmit
Power Control).
Use to enable/disable ATPC.
Use to define the ATPC update period.
Use to define ATPC remote Rx level min and max
thresholds.
Use to set modem configuration – bandwidth, minimum
and maximum modulation.
"e" suffix indicates "AES".
WEB GUI
FODUs.
41
Advertisement
