Advertisement
INTEGRA/-S/-G/-GS User Manual
12) Port status and configuration – STP parameters of every port:
RSTP state – Indicates RSTP state of the particular port (status mode);
-
allows enable or disable RSTP operation for the particular port (modify
mode);
Port state – Indicates port condition. Can be one of the following: Disabled,
-
Blocking, Listening, Learning, or Forwarding;
Role – the role of the particular port. Can be one of the following: Root,
-
Designated, Alternate, Backup, or Disabled;
Priority – Indicates Port Priority (status mode); allows specifying Port Priority
-
(modify mode). A combination of Priority, Port number, and Path Cost
determines whether the port will be selected as the Root port or will be
blocked on the occasion of a loop, etc;
Path cost – Indicates Path cost of the particular port (status mode); allows
-
specifying Path cost for the particular port by setting Path cost value or by
selecting Auto mode (modify mode). This parameter setting depends on the
capacity of a separate port;
Edge – displays that this particular port is Edge port;
-
Point-to-point – displays whether there is a point-to-point connection from
-
the particular port or not;
13) Rx MSTP BPDUs – Indicates how many MSTP BPDUs packets were received;
14) Rx RSTP BPDUs – Indicates how many RSTP BPDUs packets were received;
15) RX Conf BPDUs – Indicates how many STP BPDUs packets were received;
16) RX TCN BPDUs – Indicates how many topology changing notification BPDUs packets
were received;
17) Bad MSTP BPDUs – Indicates how many bad MSTP BPDUs packets were received;
18) Bad RSTP BPDUs – Indicates how many bad RSTP BPDUs packets were received;
19) Bad Conf BPDUs – Indicates how many bad STP BPDUs packets were received;
20) Bad TCN BPDUs – Indicates how many bad topology changing notifications BPDUs
packets received;
21) Tx MSTP BPDUs – Indicates how many MSTP BPDUs packets were sent;
22) Tx RSTP BPDUs – Indicates how many RSTP BPDUs packets were sent;
23) Tx Conf BPDUs – Indicates how many STP BPDUs packets were sent;
24) Tx TCN BPDUs – Indicates how many topology changing notification BPDUs packets
were sent;
25) Fwd Transitions – Indicates how many times the port has been changed to forward
status;
26) By pressing „Execute configuration", changes made to the corresponding section
apply only to the local side Integra/Integra-S/Integra-G/Integra-GS. If „Rollback on" is
selected, the configuration will be reverted in case erroneous configuration changes
are applied.
CLI commands
(Chapter 4: COMMAND LINE
stp status
stp bridgeID {0 | 4096 | 8192 | 12288
| 16384| 20480 | 24576 | 28672 |
32768 | 36864 | 40960 | 45056 |
49152 | 53248 | 57344 |61440}
stp helloTime <1..100>
stp maxAge <6..40>
stp forwardDelay <4..30>
stp state {enable|disable}
SAF Tehnika JSC
INTERFACE)
Use to show the status of STP configuration.
Use to set the value of Bridge ID.
Use to set the value of the time gap in seconds
between which the BPDU packets are being sent.
Use to set the time period in seconds, during which
the received BPDU packets' information is stored for a
separate port.
Use to set the time period that determines the time in
seconds a separate port stays in Listening and
Learning conditions.
Use to enable or disable RSTP operation.
WEB GUI
68
Advertisement
