INTEGRA/-S/-G/-GS User Manual
Status mode
Press
button.
Modify mode
1)
Indicates current AES status – enabled or disabled.
2) AES 256 bit key (64 hexadecimal characters) – Indicates AES key used. The key
should be exactly 64 hexadecimal characters long. A dialog window will not allow
more than 64 characters.
3)
By pressing „Execute configuration", changes made to the corresponding section
apply only to the local side Integra/Integra-S/Integra-G/Integra-GS. If „Rollback on" is
selected, the configuration will be reverted in case erroneous configuration changes
are applied.
Activation of AES for Integra/Integra-S/Integra-G/Integra-GS FODU
1) Make sure the firmware version is V2.5.13 or later.
0) If required perform the firmware upgrade.
a)
Go to "System→FW→Firmware upgrade" on the remote side of the link.
SAF Tehnika JSC
Skip this step if the firmware version is V2.5.13 or
later.
WEB GUI
54