General Safety And Service Notes - Honeywell Envitec AlcoQuant 6020 plus Operating Instructions Manual

Table of Contents

Advertisement

AlcoQuant 6020 plus
1

General Safety and Service Notes

Handling the device requires exact knowledge of these operating instructions and their
observance. The device is intended for the application described only.
Do not operate in explosion hazardous areas!
The device is not licensed for operation in explosion hazardous areas.
Portable and mobile HF communication devices can interfere with and disrupt electrical
devices.
If the AlcoQuant 6020 plus is exposed to electromagnetic radiation that corresponds with
the carrier frequency of the wireless interface, the wireless connection may be interrupted.
In that case remove the device from the radiation source and reconnect.
Commissioning
Prior to commissioning, check the calibration stickers on the device housing. If the date
shown on the plate has been reached or exceeded, the AlcoQuant 6020 plus must be
recalibrated and/or sent for servicing and should not be used for measuring. Maintenance
and calibration must be carried out by qualified and authorised personnel only.
The rechargeable batteries must be fully charged before first using the device.
The charging time in the included charger station is around 4 hours, depending on the
ambient temperature and initial battery charge level.
Maintenance
Calibration and maintenance must be performed by authorised experts at six-monthly
intervals (concluding in a report).
Maintenance work must be carried out on the device by authorised service personnel only.
Only original parts from Honeywell Healthcare Solutions GmbH may be used for repairs.
Six-monthly calibration of the device is necessary to guarantee the specified measuring
accuracy
(see specifications) over the entire period.
Safety warnings
Designates risks for man and/or machine. Non-compliance will create risks to man
and/or machine. The level of risk is indicated by the word of warning.
Important information on a topic or a procedure and other important information!
Disposal
In accordance with Directive 2002/96/EG (WEEE), after being dismantled,
electrical and electronic equipment is taken back by the manufacturer for proper
disposal!
4
Doc no.: 059-07-1001779_A6020plus_GB-5.2.1 / 12.2021

Advertisement

Table of Contents
loading

Table of Contents