Table of Contents
Advertisement
AlcoQuant 6020 plus
5.1
Battery
A repeated beep and the status display "Change battery" indicates that the batteries must be
replaced. The device switches itself off after 10 seconds. The batteries can be replaced by
lightly pressing on the battery compartment opener, which releases the lock and enables the
battery compartment cover to be removed. Then the battery block (see figure below) press
out with both hands.
The battery compartment holds a battery block with 4x LR6 (AA) alkaline Mignon batteries
(Industrial by Duracell recommended). As a general rule, all four batteries should be replaced
at the same time. Ensure the polarity of the batteries is correct. The battery block is then
reinserted into the case. The battery block connections (arrow) must face towards the device
and be on top as shown in the following image. The battery compartment cover can now be
closed again.
Do not insert rechargeable batteries of the same size (LR6, AA) in the battery block!
The battery capacity bar display on the screen will give incorrect values and device
malfunctions can occur.
28
Doc no.: 059-07-1001779_A6020plus_GB-5.2.1 / 12.2021
Advertisement
Table of Contents
