Table of Contents
Advertisement
Error Messages
Low Battery
The scale's alkaline AA type batteries are flat; please
replace the batteries.
Overload
This indicates that the scale's load sensor(s) have been
overloaded. Reduce the loading and retry.
Counting Error
The signal from the load cells is too high. Please
1.
remove any weight from the scale and try to
power on again. If the scale continues to show
the error message, it indicates a fault with the
electronics or wiring.
The signal from the load cells is too low. Please
2.
remove any weight from the scale and try again.
If the scale continues to show the error message,
it indicates a fault with the electronics or wiring.
High/Low Zero Count
The scale is above its zero range. Please remove
1.
any weight from the scale and power on again. If
the scale continues to show the error message, it
indicates a fault with the electronics.
The scale is below its zero range. Check there is
2.
nothing jammed underneath the scale and power
on again. If the scale continues to show the error
message, it indicates a fault with the electronics.
EEPROM Error
This indicates there is a fault with the scale's software and
is normally caused by a fault with the load cell or wiring.
Contact your local service representative.
Page 9 of 12
Advertisement
Table of Contents
