Advertisement
Page 3 of 9
1
Install the luminaire according to the national regulation and make
sure it that will not fall off.
18
Torque: 50 N.m
!
* No Supplied for fixing bolts, nuts and washers for luminaires.
2
Recommended
3
1. Pull caps out
at two sides.
M12（3x)
Adjusting angle of luminaire
Mounting surface is perpendicular
to luminous surface when triangle
mark pointing at 0°
Install instruction
1. No sharp edge on the interface (bracket or hole) of mounting side.
2. For below status, must replace the safe chain by a new one instantly：
!
a, The safe chain was tightened one time by luminaire falling;
b, Part of steel wire was broken；
c, While replace the luminaire, the safe chain is a falling protector, not
allowed to suspend the luminaire by a long time.
M5 (2x)
>3N.m
Another end
!
being fixed to
Safe and reliable
devices.
!
Not recommended
3. Fasten the bolts
after adjustment.
M10 (2x) 50N.m
2. Unlock bolts
at two sides for
adjusting angle.
Installation of Signify safe chain
Luminaire side
M5 (2x)
>3N.m
Signify Safety chain 911401685102(no supplied in the
luminaire) is necessary under strong vibration work
condition such as Harbour, Industry, Mining and so on.
4. Put two caps back
on the bolts.
23-07-2021
Approved
Advertisement
