Advertisement
Page 7 of 9
Warning
1. The luminaire shall be installed by a qualified electrician and wired in accordance with the latest IEEE electrical regulations or the
!
national requirements.
2. Switch off main power supply before Installation, maintenance and any operation.
3. This product contains a light source of energy efficiency class: see table or label.
Danger: electricity
4. The light source and/or control gear and/or the external flexible cable contained in this luminaire shall only be replaced by the
manufacturer or his serviceagent or a similar qualified person.
5. Use IP66 grade connection devices with cable clamp to ensure a complete IP66 system.
6. Refer to technical datasheet for additional electrical properties to ensure installation safely.
7. Luminaire installed cannot be in contact with combustible materials.
8. Ensure power supply cables (L-N / L-N-E) are connected correctly before switching on.
9. The insulation of category between LV and control circuit is basic insulation.
10.
expected.
11. Earthing contact to customer end on luminaire must be connected by installer, including whole use process that the
earthing contact is always reliably linked to earth ground.
12. The luminaire should avoid storage and usage in such a surroundings or an occasion that is with corrosion or hazardous
gases like sulfide, halide, phthalate and so on.
13. The PC material cannot be used in such an ambience that is with ethylamine, tetra-dichloroethylene, which is corrosion
or hazardous to PC material and so on.
14. Always use IP66 or higher IP rated junction box/connector for wiring connection.
15. The Luminaire should never be used in submerged wet conditions e.g. under water, soil, snow etc.
16. The wiring connection should also never be used in submerged wet conditions eg. water, soil, snow etc. OR must use
IP68 junction box.
17. The warranty is void, in case any of the instructions / guidelines are not followed as per given mounting instruction.
18. This product is not supplied with any junction box / connector.
19. For further clarification, please contact the manufacturer.
20. For 500/1000 hours of salt spray, this product is not suitable for corrosive environment , such as areas less than 1 km
from the coast, port crane, sea-crossing bridge, island; for 2000 hours of salt spray, When used in a corrosive
environment , this product may have appearance corrosion and does not affect its function, which is considered
acceptable.
21. For Australia and New Zealand：
Maintenance
1. Periodic clearing of the luminaires' optical lens covers will ensure maximum optical efficiency.
2. Luminaire optical lens cover shall be cleaned with clean water, non-abrasive soap, cleaner and detergent solution. Acid solution or
alkali solution cannot be used as a cleaning solution to wash outside surface of luminaire.
Caution
1. Luminaire must be used within the applicable product specification of installation instruction and environmental conditions for
storage and operation according to application guidelines provided by Signify for valid product warranty.
The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than 3.7 m is not
FELV terminals marked "Rick of electric shock"are not safe to touch.
WARNING:
Circuits connected to any FELV control terminal shall be insulated for the LV supply voltage of the control
WARNING:
gear and any terminals connected to the FELV circuit shall be protected against accidental contact.
Danger: electricity
23-07-2021
Approved
Advertisement
