Advertisement
DMX Attention
DMX接线注意事项
1. The different IP connectors are used in gear tray box and luminaire. Do not disassemble them.
电箱输出与灯头使用了两对不同接头，有防误接的作用，请勿随意拆卸接头。
2. The two DMX cables do not distinguish input and outout.
DMX的两根线不分输入、输出。
3. Explaination of cable color on DMX Controller:
DMX controller in line with ESTA Standard: DMX Data+(White&Orange), DMX Data-(Orange),
DMX Ground (Brown and White&Brown),
Philips iPlayer3 controller: DMX Data+(Orange), DMX Data-(White&Orange), DMX Ground (Green and White&Green).
DMX控制器输出端导线颜色说明：
符合ESTA标准的控制器：DMX Data+(白橙色), DMX Data-(橙色), DMX Ground (棕色和白棕色),
Philips iPlayer3控制器：DMX Data+(橙色), DMX Data-(白橙色), DMX Ground (绿色和白绿色)。
4. Maximum DMX data run from DMX source to last fixture in chain is 100m, maximum 16 fixtures unless booster or repeater is used.
从DMX控制器到灯串最后一个灯具的最大传输距离是100米，若不使用放大器或中继器，一个DMX控制器最多可控制16个灯具。
5. The wire connection method is determined by local electrical codes and regulations. Typical method is to use either wire nuts or
screw terminal blocks.
接线方式取决于当地电气法规及规定，一般是使用螺纹旋紧型导线连接器或螺钉接线端子。
15-12-2021
23-02-2021
Approved
Approved
Advertisement
