Related Manuals for Williams Sound Personal P.A. T18
Summary of Contents for Williams Sound Personal P.A. T18
- Page 1 FM Wireless Listening System Installation and User Manual Transmitter Model T18 Receiver Models R7, R7-4, R7-6, R700 MAN 057...
-
Page 2: Table Of Contents
PERSONAL PA BROADCASTING SYSTEM Installation and User Manual Contents: Page Overview Transmitter Controls and Features Transmitter Set-Up and Operation Antenna Connection Power Connection Audio Connection Using a Microphone Receiver Set-Up and Operation Receiver Battery Information Receiver Management Suggestions Using a Remote Antenna Troubleshooting Radio Interference / Tuning Instructions FCC Part 90 Licensing Information... -
Page 3: Overview
Designed for simultaneous language interpretation and other business applications, the T18 broadcasts to a variety of Williams Sound personal receivers including the R7, R7-4, R7-6, and R700. Federal regulations call for operators of transmitters such as the T18 to be licensed under Part 90 of the FCC Rules and Regulations. -
Page 4: Transmitter Set-Up And Operation
If you will be using the T18 with its own microphone as a stand-alone system Any Williams Sound microphone with a 3.5mm mini phone plug can be used with the T18. Plug the microphone into the "Mic" jack on the front panel of the T18. The T18 supplies positive DC voltage on the plug tip to power condenser microphones. -
Page 5: Receiver Set-Up And Operation
Overall System Diagram Microphones Sound System Amplifier Loudspeakers Line-Level Output Line-Level Input FM Pocket Receivers T18 Transmitter w/Earphones Receiver Set-Up & Operation Receiver Models R7, R7-4, R16 Step 1 Install the battery: Open the battery compartment by lifting the tab at the bottom of the receiver. -
Page 6: Receiver Battery Information
(Most batteries available through department and radio stores are 6-cell, 7.2 Volt types. They will not perform satisfactorily with Williams Sound receivers.) A fully-charged battery (Williams BAT 003) will provide about 5 hours of use per charge. The battery may be recharged without removing it from the receiver. -
Page 7: Receiver Management Suggestions
Suggestions For Receiver Management & Earphone Sanitation Different types of facilities will use different approaches for receiver management and earphone sanitation. Below are some options that customers have used successfully. Regular users purchase their own receiver and take care of their own batteries and earphone. Some facilities label the receiver and earphone with the names of regular users so each person uses the same receiver and earphone. -
Page 8: Using A Remote Antenna
RG-59 coax feedline. The feedline can be shortened if you have the tools to install a new F-connector. If you need a longer feedline, extension cables are available from Williams Sound in 50 foot lengths (WCA 008 50). Never splice coax cables together. Always use proper connectors. The cable connects to the "Antenna"... -
Page 9: Troubleshooting
Check to see that the audio light is flashing occasionally but not continuously. 5. If you are not using an input signal from a sound system, make sure the Williams Sound microphone is plugged into the "Mic" jack on the front of the T18 transmitter. - Page 10 Unless you have the necessary technical skills, this is best left to a qualified electronics repair technician. Call your Authorized Dealer or Williams Sound Corp. for more information. Ask for the Bogen Buzz Paper.
-
Page 11: Radio Interference / Tuning Instructions
The PERSONAL PA is usually not disturbed by other radio services. However, there are few clear or exclusive channels for radio services. One of the unique features of the Williams Sound PERSONAL PA System is that the operating frequency can easily be changed in the field to avoid interference. The PERSONAL PA can be quickly tuned to any of eight available frequencies by your Williams Sound Authorized Dealer. - Page 12 Frequency Change Diagrams Location Of T18 Transmitter Frequency Selector Switches T18 Selector Switches: UP (OFF) Set for 72.9 MHz 1 2 3 4 5 6 7 8 DOWN (ON) Switches set for 72.9 MHz T18 Switch Settings Table Frequency Switch Settings (MHz) 72.1 72.3...
-
Page 13: Fcc Part 90 Licensing Information
FCC License Instructions: The T18 Transmitter requires an FCC Part 90 license for legal operation. We have enclosed a license form for your convenience. Complete the form, following the instructions below, and mail it to the FCC at the address listed in step 5. - Page 14 Enter the letter code which best describes the applicant. "I" = Individual, "U" = Unincorporated Association, "P" = Partnership, "C" = Corporation, "G" = Governmental Entity. Type the name of the person signing the application. Enter the title of the person signing the application. Sign the form in this box.
- Page 15 E11: Enter the Latitude and Longitude of the county in which your office is located in degrees, minutes, and seconds. A local library can supply this information. Enter the county and state in which your office is located. E12: Skip. Schedule "G": Technical Data of FCC Form 600 Licensee Name: Enter the name of the person, business, or organization seeking the license as listed...
-
Page 16: Warranty
90 DAYS. This warranty does not extend to intentional or accidental physical damage. This warranty applies only to products returned to Williams Sound for service. To return a product for service, call the phone number on the next page and request a Return Authorization (RA) number. - Page 17 Copyright 1995, Williams Sound Corp. MAN 057...
Need help?
Do you have a question about the Personal P.A. T18 and is the answer not in the manual?
Questions and answers