SYMA X8HG User Manual page 12

*19
LI
Flight preparation and switching
off of the aircraft
I. Flight preparation
Step 1: Open up the
power supply switch
of the remote control.
Step 2. Open battery
cover, and connect
battery connector
with dash receiver.
Step 3. Enclose battery
into the fuselage, after
closing battery cover,
turn on the switch on
the bottom of aircraft.
Step 4: Push the left lever (accelerator) to the
highest point and then reset to the lowest point.
When the indicator lights in the aircraft change
from quick flashing to the continuous lighting,
it means that the aircraft goes into the flight
standby mode.
aircraft II. Switching no the
Method 1: push the left lever (accelerator) to
the highest point and then reset to the center,
the ventilation blade of aircraft starts rotating
slowly.
Method 2: Move the left and right joysticks
inwards in an internal loop of "8" for 1 second,
the ventilation blade of aircraft starts rotating
slowly.
Ill Switching off the aircraft
Method 1: Push the left joystick (Accelerator) to
the lowest level and stay there for 2 to 3
seconds, the aircraft can then be switched off.