System Dependencies And Prerequisites; Configuration Guide; Productivity Guide - GBC DocuColor 6060 Planning Manual

GBC Fusion Punch II with Offset and Bypass Stacker

System Dependencies and Prerequisites

Configuration Guide

Printer Configurations
SFM
SFM SFM
SFM IOT
SFM SFM IOT

Productivity Guide

Listed below are the dependencies and prerequisites for
installing the Fusion Punch II.
•
The Finisher Transport Module is required for in-line
connectivity to the printer.
•
A Xerox Document Stacker 5000 is recommended for
stacking paper weights greater than 203 gsm and sizes
smaller than 8.5" x 11" (216 x 279 mm) or larger than 11" x
17" (279 x 432 mm).
•
If there is a transition of an existing FP II to a Nuvera Digital
Production System, the FP II will require an upgrade.
Note: In case the floor at the customer site is very uneven, it is
recommended that the Nuvera IOT is installed and leveled with a
Caster Leveling Kit (kit number 498K07900).
The Configuration Guide contains diagrams over the various
Finishing Solutions that are available.
IOT FTM
IOT FTM
INS FTM
INS FTM
The Fusion Punch II does not require skip pitches and does not
affect the base printers output speed.
4-2
Finisher Configurations
FPII OFFSET FPII
STACKER
DS5000 FPII OFFSET
STACKER
DS5000 DS5000 FPII OFFSET
STACKER
DS5000 DS5000 FPII BYPASS
STACKER
BYPASS OFFSET
STACKER STACKER
DS5000 FPII BYPASS OFFSET
STACKER STACKER
OFFSET
STACKER