Product Overview - GBC DocuColor 6060 Planning Manual

GBC Fusion Punch II with Offset and Bypass Stacker

1. Product Overview

Fusion Punch Offset Stacker
The GBC Fusion Punch II provides in-line printer punching
combining printing and punching into one step. Single sheets are
punched and emerge ready to be finished into lay flat
documents. These types of documents are typically bound with
coil, wire or plastic comb binding and will lay flat when opened.
The Fusion Punch II can punch the long edge of an 8.5" x 11 /A4
or the short edge of an 11" x 17" / (279 mm x 432mm) / A3
sheet. A wide variety of hole-punch patterns are available. The
die sets are lightweight, do not require setup adjustment time
when changed and can be easily replaced by the operator.
The attached stacker can offset stack up to 2,500 sheets
preparing each document for immediate binding.
The Fusion Punch II can also be equipped with an optional
Bypass Stacker (the Bypass Stacker is currently not available
with the iGen3). This allows the operator to empty one stacker
while the other stacker is in use.
1-1