TMQ C-Drive 5 Installation And Service Manual page 16

Active Remote – Wiring for Active Remote, plugs into Remote socket
(Remote Mode 2).
Pin 1 +5V Power Out
Pin 2 Remote 3 Steering Signal Input
Pin 3 0v, Common Ground
Pin 4 Power steer / Auto select
Pin 5 GPS / Standby select
Pin 6 Rudder / Response select
Compass Pin
Pin 1 Coil
Pin 2 Oscillator drive
Pin 3 Coil
Pin 4 Coil
Pin 5 Coil
Note: The operation of remotes is dependent on the internal special remote
mode settings of the C-Drive amplifier. There is a range of diverse settings
which allow a boat to be customised for a given application. Consult your
dealer or TMQ Electronics for further information.
The internal terminal block in the C-Drive unit has the following
connections:
Pin 1 REMP Remote Power – 5V
Pin 2 WIP3 Wiper Input for Remote 3
Pin 3 SEL3 Select Input for Remote 3
Pin 4 Neg Negative
Pin 5 ALM- External Alarm output
Pin 6 ALM+ External Alarm output
Pin 7 Tx2 Heading Data Output (return is pin 4 – Neg)
14 of 36 TMQ C-Drive 5 Manual
Red
Green
Blue
White
Black
Yellow
TMQ Colour Code
White
Blue
Red
Yellow
Green