Advertisement
Your WorkCentre and supplies have been designed and tested to meet strict safety requirements.
These include safety agency examination and approval, and compliance to established
environmental standards. Please read the following instructions carefully before operating the
WorkCentre and refer to them as needed to ensure the continued safe operation of your
WorkCentre.
Follow all warnings and instructions marked on or supplied with the product.
Symbology:
= High Voltage,
= Heated Surface,
= Warning
= Laser Caution use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
Unplug this WorkCentre from the wall outlet before cleaning. Always use materials specifically
designated for this WorkCentre. Use of other materials may result in poor performance and could
create a hazardous situation.
Do not use aerosol cleaners. Follow the instructions in this User Guide for proper cleaning
methods.
Never use supplies or cleaning materials for purposes other than what they were intended. Keep
all supplies and materials out of reach of children.
Do not use this WorkCentre near water, wet locations, or outdoors.
Do not place this WorkCentre on an unstable cart, stand, or table. The WorkCentre may fall,
causing personal injury or serious damage to the WorkCentre.
This product is equipped with a 3-wire grounding type plug (e.g., a plug having a third grounding
pin). This plug will fit only into a grounding-type power outlet. This is a safety feature. To avoid risk
of electric shock, contact your electrician to replace the receptacle if you are unable to insert the
plug into the outlet. Never use a grounding adapter plug to connect the WorkCentre to a power
source receptacle that lacks a ground connection terminal.
This WorkCentre should be operated from the type of power source indicated on the marking label.
If you are not sure of the type of power available, consult your local power company.
Do not allow anything to rest on the power cord. Do not locate the WorkCentre where persons will
step on the cord.
The power supply cord is the disconnect device for this equipment. Insure that installation is
near the outlet and is easily accessible.
Your machine is equipped with an energy saving device to conserve power when the machine is not
in use. The machine may be left on continuously.
6
Advertisement
