Connection To The Electrical Supply - Respekta KG176W-37 Installation & Operating Instructions Manual

Remove screw hole cover (N) from the top LH side of
the refrigerator and fix it on the top RH side.
Fix top hinge (B) to the top LH side of the refrigerator
with the three previously removed screws (Fig.5.2).
NOTE: Before tightening the top hinge
screws make sure the door is perfectly
aligned with the upper part of the
refrigerator and that the rubber seal is
perfectly air tight.
Fit cover (A) on the top LH hinge of the refrigerator.
5.4

Connection to the electrical supply

Before connecting the appliance to the electrical supply, read the following information:
DANGER: Do not use adapters, multiple sockets or extension leads to connect the
appliance to the electrical supply, to avoid the risk of overheating and fire. The power
cable must be positioned so that it is not in contact with any hot surfaces at any point.
WARNING: A specialised technician must check that the home electrical system is
compatible with the power input of the refrigerator. Check the values shown on the
appliance nameplate.
WARNING: The home electrical system must be fitted with a single-pole circuit breaker/
contactor or an equivalent device, in compliance with local regulations.
WARNING: Check the power cable regularly.
If the power cable is damaged or must be replaced, this operation must be carried out
only by a specialised technician with suitable tools, to avoid the risk of injury.
WARNING: The cable must not be kinked or pinched.
en-30
N N
A A
B B
Fig. 5.13
Fig. 5.14