Danfoss Ally Application Manual page 16

Heating control

Hide thumbs Also See for Ally:

Table of Contents

Application Guide

Alarm

code

Er16

This application requires a speci c

actuator output to be available.

External PT1000 sensor not tted, or

Er17

defective.

How to install Danfoss Icon™

Danfoss Icon™ Display is a room thermostat especially designed for oor heating systems. It

comes in four di erent designs to suit markets worldwide. Danfoss Icon™ Display is very intui-

tive and easy to use. Just set your desired comfort temperature, and the thermostat will control

the room temperature in accordance with your setting.

Wake up the thermostat

Touch the screen to wake up Danfoss Icon™ Display.

The actual room temperature is displayed. Touch

to return to the previous screen. The screen turns o after

10 seconds without any action.

Set the temperature

Touch

to set the desired room temperature.

The temperature ashes to indicate setting is in progress.

Con rm your setting by touching

Heating Control Danfoss Ally™

Problem

Solution

You have already assigned this output to a room

thermostat, or the output has not yet had an

actuator tted. Please uninstall RT from TWA, it

must be available to the application chosen (or t

actuator – if this was not yet done).

Check sensor and replace if necessary

Note! Remember to ensure that the Master Control-

ler is connected due to risk of electric shock.

AB440847594423en-000103

Table of Contents