Configure The Hp-Gl/2 Print Driver To Recognize The Finisher - Xerox 6204 Installation Manual

11. Enter the following command: xesfin.exe IP_Address folder.fin, replacing "IP_Address"
with the IP Address of your printer (in this example, 13.142.199.2). A "successfully
created" message will be displayed when the .FIN file is created.
12. Start the FreeFlow Accxes Client Tools.
13. Go to Document Submit Tab > Job Options button > Finishing Tab.
14. Select "Add Folder" in the Folder Type list.
15. On the "Select a Finisher" dialog, locate the .FIN file that you just created and click "OK".
16. The folder will be added to the Folder Type list and can now be selected. The
appropriate folder methods for that folder type will be listed in the Folder Method drop
down menu.
NOTE: Only the last folder that has been added will remain in the Folder Type list between
sessions of using the Client Tools. It will also remain after you uninstall and install ACT.

Configure the HP-GL/2 print driver to recognize the finisher:

If you have a Xerox Wide Format HP-GL/2 printer driver installed on a standard TCP/IP port with
bi-directional disabled, you must follow the procedure below to configure the driver to recognize
the finisher.
1. Go to the Printers Folder:
For Windows 2000: Select Start > Settings > Printers
For Window 2003 or XP: Select Start > Control Panel > Printers and Faxes
2. Select the icon for the Xerox Wide Format HP-GL/2 printer and right-click it.
3. Select "Properties".
4. Select the "Device Options" tab.
5. In the "Finisher type" combo box, select "<add finisher>".
6. In the "Open Finisher Description File" dialog, navigate to the location of the .FIN file
created above.
7. Select the .FIN file, and click "OK".
8. Click "OK".
Use the Finishing controls on the Job tab in Printer Preferences to configure the driver further.
14 Xerox FreeFlow Accxes Drivers & Client Software Installation Guide