Table of Contents
Advertisement
Installing the holding bracket
Place the holding bracket on the
marking on the toe-kick.
In the middle of the two outer slotted
holes, mark a point for each drill hole.
Drill 2 holes 5/16" (8 mm) with a
depth of approx. 2 3/16" (55 mm).
Insert the plugs in the holes.
Install the holding bracket with the
hex screws and the washers.
Do not tighten the screws yet – this
will allow the holding bracket to be
moved sideways.
Installation and connection
Securing the washing machine with
the holding bracket
Push the washing machine back on
to the installed holding bracket.
Insert the appliance feet (the part be-
tween the foot and the locknut) into
the openings in the holding bracket.
Push the holding bracket to the right
as far as it will go.
Tighten the hex screws using a
wrench.
The washing machine is secured in the
holding bracket.
77
Advertisement
Table of Contents
