Wall Mounting The Ap With Horizontal Kit - Cisco C9124AXE-E Installation Manual

Installation Overview

Wall Mounting the AP with Horizontal Kit

Caution The mounting wall, attaching screws, and wall anchors must support the least 50-lb (22.7-kg) static weight.
The installer must supply proper screws and anchors in accordance with local codes.
Before you begin
Ensure that you have the following materials before beginning to mount the AP horizontally to a wall:
Table 9: Materials Needed for Mounting the AP using AIR-MNT-HORZ1= Kit
Materials Required
Wall/Pole Mount L-Bracket
Solar Shield Cover
(4) M6 x 12-mm Hex-head Bolts
(2) Adjustable Band Clamps 2 to 5 inch (51 to 127 mm) Dia
(4) 8-32 x 0.62" Phillips Pan Head Screw
(4) wall screws and anchors (specified for wall material)
Drill bit for wall anchors
10–mm box-end wrench or socket set
Phillips Screwdriver
Procedure
Step 1 Use the mounting bracket as a template to mark four screw hole locations on the mounting wall. See
63: Wall mount L-bracket screw hole dimensions, on page 56
and dimensions. See
L-bracket.
Figure 64: L-bracket AP mount dimensions, on page 56
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
Wall Mounting the AP with Horizontal Kit
Supplied in the
Kit?
Yes
Yes
Yes
Yes
Yes
No
No
No
No
for the mounting bracket screw hole locations
for dimensions of the mounting
Figure
55