Table of Contents
Advertisement
Installation Overview
Figure 78: Terminating DC plug to the cable
1
DC 2-conductor 18 AWG cable
2
Crimp Pins
3
Seal Nut
Figure 79: Wire Stripping Length
1
a) Dis-assemble the DC plug .
b) Pass the cable through the plug components.
c) Strip the cable end.
Note
d) Insert wire conductor into crimp pins. Using a 0.10 inch (2.54 mm) Hex crimp tool, crimp the pin to the
wire to secure it in place. Repeat for the second pin. If you must re-do the crimping process, you can use
the 2 extra pins supplied.
e) Insert the crimped pins and wire into the female barrel of the connector body. Be sure to insert the proper
wire polarity into the corresponding barrel shown on the body. Push to be sure the pin is fully seated into
the barrel.
Note
cable
Remove the wire jacket and tin the wire strands. Tinning the strands helps to insert the wire
into the crimp pins.
Pin 1 (+V) Pin 2 (-V), the connector body is marked (+) and (-) to show polarity pin assignments.
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
Connecting a DC Power Cable to the Access Point
4
Grommet and Seal Ring
5
Gasket
6
Connector body
71
Advertisement
Table of Contents
