Table of Contents
Advertisement
Pole Mounting the AP with Horizontal Kit
Materials Required
(4) M6 x 12-mm Hex-head Bolts
(2) Adjustable Band Clamps 2 to 5 inch (51 to 127 mm) Dia
(4) 8-32 x 0.62" Phillips Pan Head Screw
(4) wall screws and anchors (specified for wall material)
Drill bit for wall anchors
10–mm box-end wrench or socket set
Phillips Screwdriver
Procedure
Step 1
Select a mounting location on the pole to mount the AP. You can attach the AP to a pole with a diameter of
2 to 5 inch (51 to 127 mm).
Step 2
Hold the bracket up against the pole, slide the two band straps through the top and bottom sets of mounting
slots on the mounting bracket, see
57.
Step 3
Wrap the band straps around the pole, lock them, and lightly tighten the clamps using a wrench. Only tighten
them enough to keep the bracket from sliding down the pole.
Step 4
Position the AP horizontally against the L-bracket's bottom to align the four mounting holes on the AP's back
with the slots in the mounting bracket.
Note
Step 5
Screw an M6 x12–mm bolt into each of the four support bolt holes on the back of the AP by hand. Do not
completely tighten the bolt. Leave it loose to slide in the bracket slot.
Step 6
Hold the AP position to its final position. Tighten the band clamps with the wrench so that the AP does not
slide or rotate on the pole. Ensure that the clamps are tight enough not to let the AP move. Ensure that the AP
and all attached cables have clearance to install and provide drip loops.
Step 7
Using a 10–mm wrench, tighten the four M6 bolts to 40–lbf-in (4.5 Nm) torque.
Step 8
Position and install the solar shield on top of the L-bracket and AP. Align four holes in the shield to mount
holes in AP. Insert four #8-32 screws through the shield into AP. Torque tighten the screws to 15 lbf-in (17
kgf-cm).
Note
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
58
Figure 65: Pole Mounted Horizontal Kit (AIR-MNT-HORZ1=), on page
The AP has additional mounting holes to be positioned and located to best accommodate on site
cabling. Ensure to review before mounting the AP to the bracket.
We recommend you install the solar shield. However, if the AP's installed location is shaded from
the sun (For example: indoors or under an eave), the solar shield is not required.
Installation Overview
Supplied in the
Kit?
Yes
Yes
Yes
No
No
No
No
Advertisement
Table of Contents
