Choosing A Mounting Kit; Wall Mounting The Ap Using The Meraki Kit - Cisco Catalyst Wireless 9163E Manual

Installing the Access Point

Choosing a Mounting Kit

Access Point Mounting Kit
You can mount the AP vertically to a wall or a pole that best fits the installation application.
AP Mounting Kit
MA-MNT-MR-16
AIR-MNT-VERT1=
2
Note
Mounting Antenna
The procedure to install the supported antenna to the AP.
Antenna
CW-ANT-O1-NS-00
External GNSS mount
Note

Wall Mounting the AP using the Meraki Kit

The MA-MNT-MR-16 mounting kit contains a mounting bracket for wall mounting or pole mounting.
2
Purpose
Fixed mounting kit for vertical mounting on a wall or for pole of diameter
2 to 3.9 inch (51 to 99.06 mm). See:
Wall Mounting the AP using the Meraki Kit, on page 19
Pole Mounting the AP using the Meraki Kit, on page 22
Fixed mounting kit for vertical mounting on a wall or for pole of diameter
2 to 3.9 inch (51 to 99.06 mm). See:
Wall Mounting the AP using the Cisco Kit, on page 23
Pole Mounting the AP using the Cisco Kit, on page 26
Mount the AP using no less than four screw holes on a bracket.
• When mounting an AP vertically, ensure that the AP is oriented with the LED indicators pointing down.
• Mount the AP in such a way that all antenna ports and the console port are visible and accessible for
future use.
• Align the AP's omnidirectional antennas vertical to the ground.
Cisco Catalyst Wireless 9163E Access Point Hardware Installation and Deployment Guide
Purpose
Installing the Omnidirectional Antenna, on page 35
Mounting kit to install the GNSS antenna on a wall or pole of
diameter 2 to 3.9 inch (51 to 99.06 mm). See:
Wall Mounting the GNSS Antenna, on page 35Pole Mounting the
GNSS Antenna, on page 36
Choosing a Mounting Kit
19