Reelmotors; Mechanical Checks And Adjustments; Cassette Holder Timing Adjustment - Teac C-1 Service Manual

LUBRICATION
Lubrication should be generally done at about every 1,000
hours of operating time of the tape deck. Use high quality
oil for this purpose.
For efficient oiling, it is recommended that lubrication be
done after nearly 1 hour of idling of the deck and while it
is still warm.
L,
nN
Apply a drop of a light machine oil of good quality (e.g.:
TEAC TZ-255) with an oil applicator to the shaft of the
flywheels and spread oil evenly over the shaft with a
flannel cloth. After installing the flywheel, be sure to
clean the tape moving portion of shaft with TEAC TZ-
261 A head cleaner or with pure alcohol.
. Apply a drop of the proper oil in the same way as above
to the innermost area of capstan shaft (next to the fly-
wheel).
. Apply a film of light grease to the well of the flywheel
bearing (See Fig. 4-7.)
4-8 REEL MOTORS
Preparations
Remove in number-order.
DROP WN
. Fig. 4-1, 1-thru-18 except 10.
. Fig. 4-2, 1, 3.4.
. Fig. 4-3, 1-thru-6.
. Fig. 4-4, 1, 2,3.
. Fig. 4-7, 1, 2,3.
. Fig. 4-8, 4,5, 6, 7, 8,9.
Fig. 4-9 Reel motors
5. MECHANICAL CHECKS AND ADJUSTMENTS
5-1 CASSETTE HOLDER TIMING
ADJUSTMENT
. Insert any standard cassette tape into the cassette holder
and push the holder into the lock-close position.
. Turn the set screw so that at the moment the cassette
pressure lever clamps down onto the cassette, the lock
cam will snap down onto the lock plate.
Secure the screw with a drop of locking paint after com-
pleting the above procedures.
Casstte Pressure
Lock Cam
Lever
Cassette
Lock Plate
Set Screw
T-1350-1
Fig. 5-1 Cassette holder timing adjustment