Configuring Ip, Subnet, And Gateway Addresses - Xante AW 1200 Quick Reference Manual

Xante aw 1200: reference guide
Hide thumbs Also See for AW 1200:
Table of Contents

Advertisement

Installation-Windows 98/Me (continued)
Fig. 78 Select Device Options to Configure
your Printer. Click Apply, then OK.
Note:
Make changes for options installed
on your printer by first highlighting
the option. Then, select the setting
under Change Setting.
Fig. 79 Setup Complete. Click Finish.
Note:
If you selected to read the ReadMe
file, do so and then, close the
window.
Configuring IP, SubNet, and Gateway
Addresses
1.
From the ps_files folder on the XANTÉ
CD-ROM, copy dhcpoff.ps to your c:\
drive.
2.
Go to DOS (Command) Prompt.
3.
Type copy dhcpoff.ps to lpt1.
4.
Power cycle the printer (turn off, then
back on).
5.
Using a word processing application,
open setipsub.ps file from the ps_files
folder. Edit the file so it contains the IP,
Subnet, and Gateway address you
obtained from your network administra-
tor. Save the file to your c:\ drive.
17
6.
Go to DOS (Command) Prompt.
7.
Type copy setipsub.ps to lpt1.
8.
Power cycle the printer again and verify
that the start-up page contains your IP,
Subnet, and Gateway addresses.
9.
Go to DOS (Command) Prompt to ping
the printer.
c:\ping (IP Address)
Note:
If you can ping the printer, go on to
step 10. If you cannot ping your
printer, contact your Network
Administrator.
10. Go to your Printer Properties (fig. 80) and
select the Details Tab (fig. 81).

Advertisement

Table of Contents
loading

Table of Contents