Table of Contents
Advertisement
Installation - Windows 98/Me (continued)
Note:
If you selected to read the
ReadMe file, do so and then,
close the window.
Configuring IP, SubNet, and Gateway
Addresses
1. From the ps_files folder on the
XANTÉ CD-ROM, copy dhcpoff.ps
to your c:\ drive.
2. Go to DOS (Command) Prompt.
3. Type copy dhcpoff.ps lpt1.
4. Power cycle the printer (turn off,
then back on).
5. Using a word processing application,
open setipsub.ps file from the
ps_files folder. Edit the file so it
contains the IP, Subnet, and Gateway
address you obtained from your
network administrator. Save the file
to your c:\ drive.
6. Go to DOS (Command) Prompt.
7. Type copy setipsub.ps lpt1.
8. Power cycle the printer again and
verify that the start-up page contains
your IP, Subnet, and Gateway
addresses.
9. Go to DOS (Command) Prompt to
ping the printer.
c:\ping (IP Address)
Note:
If you can ping the printer, go on
to step 10. If you cannot ping
your printer, contact your
Network Administrator.
10. Go to your Printer Properties (fig. 68)
and select the Details Tab (fig. 69).
17
Fig. 68 Printer Properties Window.
Advertisement
Table of Contents
