Table of Contents
Advertisement
Installation-Windows NT/2000/XP (continued)
Fig. 105 Click Configure Port.
Fig. 106 Select LPR and Enter a Queue
Name. Click OK.
Note:
Be sure to close the Properties
window to apply the new settings.
Configuring IP, SubNet, and Gateway
Addresses
1.
From the ps_files folder on the XANTÉ
CD-ROM, copy dhcpoff.ps to your c:\
drive.
2.
Go to DOS (Command) Prompt.
3.
Type copy dhcpoff.ps to lpt1.
4.
Power cycle the printer (turn off, then
back on).
5.
Using a word processing application,
open setipsub.ps file from the ps_files
folder. Edit the file so it contains the IP,
Subnet, and Gateway address you
obtained from your network administra-
tor. Save the file to your c:\ drive.
22
6.
Go to DOS (Command) Prompt.
7.
Type copy setipsub.ps to lpt1.
8.
Power cycle the printer again and verify
that the start-up page contains your IP,
Subnet, and Gateway addresses.
9.
Go to DOS (Command) Prompt to ping
the printer.
c:\ping (IP Address)
Note:
If you can ping the printer, go on to
step 10. If you cannot ping your
printer, contact your Network
Administrator.
10. Go to your Printer Properties (fig. 107)
and select the Port Tab (fig. 108).
Advertisement
Table of Contents
