Power Requirements; Input Loading; Outputs; Initial Inspection - HP 10343B Operating Manual

Power
Requirements
The HP 10343B draws approximately 0.80 amps at + 5 V from the
HP 1630A/D/G or HP 1631A/D Logic Analyzer.
Input Loading
The even numbered signal lines have an input impedance of 5k ohms tied
to
25
volts. The odd numbered signal lines have an input impedance of
10k ohms tied to
25
volts.
Each signal line has a
maximum
length of
10
centimeters inside of the
interface to conform to the single-ended
SCSI
specification.
Outputs
The HP 10343B does not output any signals to the
SCSI
Bus.
Initial
Inspection
Inspect the shipping container for damage. If the shipping container or
cushioning material is damaged, it should be kept until the contents of the
shipment have been inspected mechanically and electrically. If the
contents are incomplete, if there is mechanical damage or a defect, or if
the instrument does not operate, notify your nearest Hewlett-Packard
Sales and Service Office. If the shipping container is damaged, or the
cushioning materials show signs of stress, notify the carrier as well as
Hewlett-Packard. Keep the shipping materials for inspection by the
carrier.
General Information
1-2