Chapter 3: Hp 10343B Inverse Assemblers; Introduction; Selecting The Correct Inverse Assembler - HP 10343B Operating Manual

HP 10343B Inverse Assemblers
3
Introduction
Selecting the
Correct Inverse
Assembler
The HP 10343B has ten inverse assemblers available for use with the
HP 1630A/D/G and HP 1631A/D Logic Analyzers. These give you the
flexiblity of selecting the correct inverse assembler to decode any of the
different device types that are called out in the SCSI Standard
X3T9.2/86-109 Revision 2.
The interpretation of the SCSI Command Sets vary in each inverse
assembler to match the applications of various device- types. Only one
inverse assembler can be used at a time.
The HP 1630A/D/G or HP 1631A/D Logic Analyzer is configured for
SCSI Bus analysis by loading the appropriate inverse assembler and then
loading the configuration file. Each time you load a new inverse
assembler you must reload the configuration file.
Note
If you do not want to lose your current data, you must save your
data before loading a different inverse assembler into the logic
analyzer.
HP 10343B Inverse Assemblers
3-1