Lincoln Electric 12926 Operator's Manual page 23

VRTEX 360, 360+, TRANSPORT, TRANSPORT+
®
STAND ASSEMBLY
The stand is comprised of the post, arm (connected to the machine),
table, three pins, base and two weights. Users should position
themselves at the stand during virtual welding. The weights must
be attached to the stand with included hardware.
POST
The arm and table slide up and down and rest on the collar pins
that are inserted into the post. Hole numbers 1 through 28 indicate
position of welding for program accuracy. The position that the table
or arm is located is read by identifying the numbered hole that the pin
has been inserted into.
Figure 14 – Post w/pin inserted in #13
PIN POSITION
COUPON POSITIONING IN SWING ARM
The coupons can be inserted into the arm to accommodate flat,
horizontal, vertical or overhead welding positions. The knob on the
front of the swing arm can be pulled out for coupons to be inserted or
removed and pushed in for coupons to be secured. The front of the
swing arm can be rotated down at a 45 or 90-degree angle to allow
2G, 5G and 6G pipe welding positions. The arm can also be rotated
around the post to comfortably accommodate left and right handed
welders or simulate specific welding applications.
Figure 15 – Coupon insertion / removal
CAUTION
Do not use excessive force when inserting and
removing coupons into the arm.
Figure 16 – Swing arm rotation
TABLE
The table can be used to gain stability and learn proper body
positioning. The base supports the stand and has weights on the
back to maintain stability. The table can be swung out of the way
when not in use. The table also has storage compartment for the
coupons.
CAUTION
Do not use the Stand/Table without the base counter
weights properly positioned.
14
INSTALLATION