BRP ADVEX User Manual page 17

B. THE HELMET
12. INNER LINER
REMOVING THE CHEEK PADS
1. With the face shield in the open
position, detach the Velcro and the 3
TM
snaps by pulling the cheek pad towards
the inside of the helmet.
2. Slide the chinstrap into the cheek pad
notch.
3. Repeat these steps for the other side.
INSTALLING THE CHEEK PADS
1. Before installing the cheek pads,
identify the right and the left sides.
2. Fasten the 3 snaps and attach the
Velcro TM upper part in position. Make
sure the strap is in position inside the
cheek pad notch.
3. Repeat these steps for the other
side.
REMOVING THE HEAD LINER
1. First, remove the rear portion of the
head liner. The head liner is attached to
the inner shell with 2 snaps (on each
side of the neck) and a frontal portion,
with 3 plastic strips.
2. Then you can remove the frontal
portion by pulling the 3 snaps. They can
be removed by pulling them out
carefully.
For the frontal portion, start to pull from
one side of the plastic strip.
16