BRP ADVEX User Manual page 21

C. FIT & USAGE
4. OPERATING INSTRUCTIONS
2. Power cable (vehicle side)
• Connect the vehicle power cable to the main power outlet and leave it in
position for further use.
3. RCA power cable
• Then, place your riding coat on a clean surface and route the power
cable as shown below:
TYPICAL
4. Final connection
• Once the power cable is in place, put on your coat and let the power
cable pass under your left or right arm, depending which side is your key
ring on your jacket;
• Put on your helmet as described in the "1. HOW TO PUT HELMET ON"
section of this manual.
• Grab the power cable at the back of your neck and bring it closer to the
connection housing of the helmet.
• Next, grab the cable end and connect it to the vehicle power cable.
Ensure that the cables stay away from any moving parts. Do not let the
power cables become entangled in the vehicle and do not drive over
them. Only use BRP approved extension cord. If the cables are
damaged, stop using them. Discard and replace them with new OEM
BRP cables.
The magnets contained in this helmet could interfere with the operation of
electronic devices such as pacemakers. Please consult your doctor
before wearing this product.
Also, note that the credit cards' magnetic stripe could be affected.
WARNING
WARNING
20