Breath Guard - BRP ADVEX User Manual

B. THE HELMET
4. MICROMETRIC CHIN STRAP
OPENING AND CLOSING
To close the chinstrap fastener, slide the ratchet tongue step by step into
the locking buckle. If you find that the chinstrap fits too loosely around your
chin, slide the ratchet tongue one step further into the locking buckle.
When adjusting the chinstrap, make sure that it rests firmly but not
uncomfortably around your chin. To open the chinstrap, pull the red ribbon
on the ratchet fastener upwards to release the locking buckle. Then pull
the ratchet tongue out of the locking buckle.
WARNING
Never ride without making sure that the chinstrap is correctly fastened
and adjusted and properly positioned. If the chinstrap is not correctly
adjusted or fastened, the helmet could be displaced in the event of an
accident.
WARNING
Closing the comfort pad of the chinstrap alone will not provide adequate
protection. The chinstrap must always be fully fastened.
WARNING
Never open the chinstrap while riding.

5. BREATH GUARD

The ADVEX helmet's breath ventilation system contributes greatly to the
overall performance of the helmet and the comfort of the wearer.
This system is designed to be easy to use and to allow the operator to
focus on the trail rather than on the fog.
INSTALLATION AND ADJUSTMENT
For optimal performance of the ADVEX helmet, it is essential to ensure
that the breath guard is properly installed and adjusted.
1. Slightly lift open the face shield.
2. Ensure that the breath guard is
securely attached, then adjust
pressure of the breath guard on the face
by pulling the adjustment pull tab.
3. For optimum performance, it is
important to adjust properly in order to
obtain a tight seal between the face and
the breath guard.
the
8