Table of Contents
Advertisement
User Manual
XTOXLnie/ XTOXLnce
Preventive Maintenance
CLEANING INSTRUCTIONS
WARNING!
Dangerous situations may arise during maintenance and cleaning work. Accidents
may occur if the relevant safety instructions are not observed!
➔ Switch off the machine before cleaning or maintenance and pull out the mains
power connecting line!
➔ Never allow liquid to get into the machine!
➔ Repairs to the machine must only be made by trained service technicians!
Cleaning agents
CAUTION!
Sharp cleaning materials may damage the printer.
➔ Do not use any cleaning agents or materials that could damage or destroy the
paint finish, labelling, display, type plates, electrical component etc.!
➔ Do not use abrasive cleaners or cleaners which could damage the plastic!
➔ Do not use acid or alkaline solutions!
Note: dirty environments may require shorter intervals between preventive maintenance routine.
Preliminary operation
If access to the inside of the printer is not convenient (especially in the case of a model with a 6"
print-head), before each cleaning operation it is advisable to remove the front bar by pressing the
side buttons (s) inwards.
ATTENTION! when repositioning the bar, be very careful to centre the bearing (b) in
the support bar, so as not to cause it to break.
Edition 01 - 11/2022
b
s
Figure 75: removing the support bar
NOTE: Also carefully clean the
inside of the front bar and the
bearing [b] with a soft cloth
before reassembling the bar.
s
59
Preventive MAINTENANCE
Advertisement
Table of Contents
