Table of Contents
Advertisement
28 / 46
Electric installation
The 24 V voltage supply can be grounded. For more detailed information, refer to the docu-
mentation of the power supply unit.
Use only power supply units that can bridge a half-wave failure (10 ms).
10.5.2 Power connector XD10
The control is supplied via the XD10 power connector.
Use only copper wires to connect the connection terminals.
Only the power connector is permitted to connect the 24 V supply voltage for the control (see
⮫ Chapter 5.1 "Power connector, 24 V" on page
The power connector has a maximum number of 50 mating cycles. The mating cycles of the
cables in the XD10 power connectors are limited to 50.
Fig. 13: Power connector XD10
Table 7: Pin assignment of the power connector XD10
Plug contact
Signal
1
24 V
2
0 V
3
24 V
4
0 V
Mounting notes:
•
For the power connector XD10, one-wire cables and stranded cables can be used with or without
wire end ferrule (acc. to DIN 46228). These wire end ferrules can be with or without plastic collar.
The contact surface has to be 8 mm.
•
The cable cross-section allowed is between 1 and 1.5 mm
•
Use only cables approved for temperatures of at least 60°C.
•
Use freely routed 1-wire cables. The wire distance has to be at least the wire diameter.
•
The stripping length is 8 mm.
Bosch Rexroth AG
11).
1
2
Function
DC +24 V supply voltage (U
GND (U
) (supply voltage grounding)
P
DC +24 V supply voltage (U
GND (U
) (supply voltage grounding)
L
3
4
)
P
)
L
(AWG 16, AWG 17).
2
R911420136, Edition 01
ctrlX CORE
X3
plus
Color
Red
Blue
Red
Blue
Advertisement
Table of Contents
