Table of Contents
Advertisement
5.3 Setting Home Position
PTZ camera will return to home position if no operation is made within a specified period.
NOTE!
This function is available for network PTZ cameras only.
You need to add presets or a patrol route first. See Add a preset and Add a patrol routefor details.
1.
Click Setup>PTZ>Home Position.
2.
Select a mode and ID.
3.
Click Save.
5.4 Remote Control PTZ
When the third-party platform is used and the PTZ protocol does not match that, you can set the remote
control function to control the PTZ.
NOTE!
This function is only supported by PTZ cameras.
1.
Click Setup>PTZ>Remote Control.
2.
Select On to enable Remote Control. Set the listener port and address code.The following table
describes some major parameters.
Acronym
Listener Port
Address Code
3.
Click Save.
Camera's local port, which cannot be a port that is already in use. Change
the default setting only when necessary.
The camera can read the address code contained in instructions. The
camera interprets the instruction only when the address code in the
instruction is the address code configured here.
34
UNI IP Series Network Cameras – H265, 2MP / 5MP
Description
Advertisement
Table of Contents
