Page 1
WhatsApp community↑ J3L101BS01 As this item contains many parts, please read the installation instruction carefully before installation . Please use tools properly and carefully. If you have any questions about the product and installation, please contact us. service@vabchesofficial.com Our professional after-sales team will serve you online all day.
Before You Start Read through each step carefully and follow the proper order Separate and count all your parts and hardware Give yourself enough room for the assembly process Have the following tools: Flat Head Screwdriver, #2 Phillips Head Screwdriver and Hammer Caution: If using a power drill or power screwdriver for screwing, please be aware of to slow down and stop when screw is tight.
Board Identification Not actual size LEFT SIDE PANEL RIGHT SIDE PANEL Qty:1 Qty:1 Qty:1 BACK PANEL FIXED SHELF HUTCH SIDE PANEL Qty:1 Qty:1 Qty:1 BACK PANEL BOTTOM FRONT RAIL FRONT PANEL Qty:1 Qty:2 Qty:1 3/24...
Board Identification Not actual size REAR PULL BAR BIG DRAWER FRONT DRAWER LEFT SIDE Qty:1 Qty:1 Qty:1 DRAWER RIGHT SIDE DRAWER BOTTOM DRAWER BACK PANEL Qty:1 Qty:3 Qty:1 SMALL DRAWER FRONT DRAWER LEFT SIDE DRAWER RIGHT SIDE Qty:2 Qty:2 Qty:2 4/24...
Page 5
Board Identification Not actual size FRONT PULL BAR DRAWER RIGHT SIDE Qty:1 Qty:2 5/24...
Part List ∅ 6X35mm ∅ 6X30mm ∅ 4X35mm ∅ 15X9.5mm CAM LOCK CAM BOLT WOOD DOWEL SCREW spare : 2 spare : 2 spare : 2 spare : 2 ∅ 3X12mm ∅ 6X10mm 12" 12" SCREW SCREW LEFT CABINET MEMBER RIGHT CABINET MEMBER spare :...
Page 7
Part List 35mm ∅ ∅ 3.5X14mm GROMMET LIGHT STRIP SNAP SCREW spare : 1 spare : 2 Cam Lock Fastening System Insert the cam bolt into the hole first, then insert the cam lock and lock it. The opening must point toward the edge of the board 7/24...
Page 8
Board Identification Not actual size 8/24...
Page 9
STEP1 ∅ 6X35mm ∅ 6X30mm ∅ 3X12mm FINISH The direction is consistent 9/24...
Page 17
STEP9 ∅ 6X30mm Pay attention to the orientation 17/24...
Page 18
STEP10 Before installing the strip, remove MODE SPEED DEMO SPEED COLOR MODE BRIGHT COLOR BRIGHT the protective film on the strip ∅ 15X9.5mm X1set For better installation below, just put the light strip hardware No. 11 in the position shown in the figure Proper orientation of CAM LOCK 18/24...
Page 19
STEP11 ∅ 21mm ∅ 4X35mm The No. 11 light strip is inclined into the No. 15 buckle first, and then press the other side with your hand to enter the buckle 19/24...
Page 22
STEP14 3.5X14mm ∅ 12" 12" Third Hole 22/24...
Page 23
STEP15 ∅ 3X12mm M4*16mm 104*5*16mm Insert the plastic buckle into the back plate slot, screw through the hole in the plastic buckle and lock it in place. ∅ 3*14mm X6set Cabinet Slide Drawer Slide 23/24...
Page 24
RGB LED Controller Instrustions You can use the switch or remote to control the lighting effects. Description of switch function 1. Power on/off:Press and hold the power button. 2.Change the mode:Short press the cycle button.(Multiple mode options:Static Red/Static Green/Static Blue/Static White/Multicolor Blinking/Multicolor Breathing/Red Cycle Button Breathing/Blue Breathing/Green Breathing)