Page 1
JY9993BS01 JY9993HS01 JY9993GR01 As this item contains many parts, please read the installation instruction carefully before installation . Please use tools properly and carefully. If you have any questions about the product and installation, please contact us. service@vabchesofficial.com Our professional after-sales team will serve you online all day.
Page 2
Before You Start Read through each step carefully and follow the proper order Separate and count all your parts and hardware Give yourself enough room for the assembly process Have the following tools: Flat Head Screwdriver, #2 Phillips Head Screwdriver and Hammer Caution: If using a power drill or power screwdriver for screwing, please be aware of to slow down and stop when screw is tight.
Page 3
Board Identification Not actual size LEFT SIDE PANEL RIGHT SIDE PANEL Qty:1 Qty:1 Qty:1 BOTTOM BOARD FIXED SHELF FIXED SHELF Qty:1 Qty:1 Qty:1 UPPER BACK PANEL LOWER BACK PANEL STRIP LIGHT Qty:1 Qty:1 Qty:1 3-24...
Page 4
Board Identification Not actual size BOTTOM FRONT RAIL DRAWER FRONT DRAWER LEFT SIDE Qty:1 Qty:2 Qty:2 DRAWER BOTTOM DRAWER BACK PANEL DRAWER RIGHT SIDE Qty:2 Qty:2 Qty:2 DRAWER PULL PLATE SMALL DRAWER FRONT Qty:1 Qty:1 4-24...
Page 6
Part List ∅ 4X40mm ∅ 3*14mm X6set SCREW BACK PANEL BUCKLE spare : 1 spare : 1 Cam Lock Fastening System Insert the cam bolt into the hole first, then insert the cam lock and lock it. The opening must point toward the edge of the board 6-24...
Page 7
Board Identification Not actual size 7-24...
Page 12
STEP5 15X9.5mm ∅ Install Part A and place the wires on Part G into the C part slot in their natural state. Proper orientation of CAM LOCK 12-24...
Page 17
STEP10 ∅ 4X40mm ∅ 21mm Before installing the size 15 screw, make sure that the F part is horizontal and that the holes in the F part are aligned with the holes in the B and C parts 4X40mm ∅ 17-24...
Page 22
STEP15 3X12mm ∅ ∅ 3*14mm X6set Insert the plastic buckle into the back plate slot, screw through the hole in the plastic buckle and lock it in place. 22-24...
Page 24
RGB LED Controller Instrustions You can use the switch or remote to control the lighting effects. Description of switch function 1. Power on/off:Press and hold the power button. 2.Change the mode:Short press the cycle button.(Multiple mode options:Static Red/Static Green/Static Blue/Static White/Multicolor Blinking/Multicolor Breathing/Red Breathing/Blue Breathing/Green Breathing) Cycle Button...