Page 1
WhatsApp community↑ J3L210BS01 J3L210HS01 As this item contains many parts, please read the installation instruction carefully before installation . Please use tools properly and carefully. If you have any questions about the product and installation, please contact us. service@vabchesofficial.com Our professional after-sales team will serve you online all day.
Before You Start Read through each step carefully and follow the proper order Separate and count all your parts and hardware Give yourself enough room for the assembly process Have the following tools: Flat Head Screwdriver, #2 Phillips Head Screwdriver and Hammer Caution: If using a power drill or power screwdriver for screwing, please be aware of to slow down and stop when screw is tight.
Board Identification Not actual size DESK TOP LEFT SIDE PANEL RIGHT SIDE PANEL Qty:1 Qty:1 Qty:1 PARTITION FRONT SLAT REAR PANEL Qty:1 Qty:1 Qty:1 BACK SLAT HUTCH LEFT SIDE PANEL HUTCH LEFT BACK PANEL Qty:1 Qty:1 Qty:1 DRESSING MIRROR FIXED SHELF FIXED SHELF Qty:1 Qty:1...
Page 4
Board Identification Not actual size FIXED SHELF LEFT DRAWER FRONT RIGHT DRAWER FRONT Qty:1 Qty:1 Qty:1 DRAWER LEFT PANEL DRAWER RIGHT PANEL DRAWER BACK PANEL Qty:2 Qty:2 Qty:2 DRAWER BOTTOM STOOL SIDE PANEL STOOL FRONT APRON Qty:2 Qty:2 Qty:1 STOOL BACK APRON STOOL BOTTOM BOARD SPONGE CUSHION Qty:1...
Part List Ø15X9.5mm Ø6.5X35mm Ø6X30mm Ø8X30mm CAM LOCK CAM BOLT WOODEN DOWEL WOODEN DOWEL spare:2 spare:2 spare:3 spare:2 Ø6.3X50mm Ø3.5X14mm Ø3X12mm Ø4X40mm SCREW SCREW SCREW SCREW spare:2 spare:3 spare:1 spare:3 Ø4X14mm 50X20X2mm Ø25mm SCREW IRON SHEET HINGE THE POWER PLUG spare:1 Ø21mm 4X65mm...
Page 6
Part List X1 set ANTI-TIPPING HARDWARE Cam Lock Fastening System Insert the cam bolt into the hole first, then insert the cam lock and lock it. The opening must point toward the edge of the board 6-28...
Page 7
Board Identification Not actual size 7-28...
Page 22
STEP15 Ø6X30mm Ø15X9.5mm Insert the cam bolt into the hole first, then insert the cam lock and lock it. Proper orientation of CAM LOCK 22-28...
Page 24
STEP17 Ø15X9.5mm Ø6.3X50mm Ø4X40mm Ø21mm Insert the cam bolt into the hole first, then insert the cam lock and lock it. Proper orientation of CAM LOCK 24-28...
STEP20 When making upcan use the switch to turn on or off the light. the dressing table brings you 3 temperature light modes, touch the button you can easy light up the mirror and changeet your different needs, long press to adjust the brightness. TOUCH SWITCH 27-28...
Page 28
STEP21 We have included a set of tipping restraint hardware for NOTE this unit. You must install this hardware to prevent :The tipping restraint hardware included is for accidents or injuries that can result from the unit falling. wooden stud wall construction. It must be attached to a When properly installed, this restraint can provide wall stud.