Page 1
WhatsApp community↑ D8L246BS01 As this item contains many parts, please read the installation instruction carefully before installation and complete the installation with the cooperation of your partner. Please use tools properly and carefully. If you have any questions about the product and installation, please contact us.
Before You Start Read through each step carefully and follow the proper order Separate and count all your parts and hardware Give yourself enough room for the assembly process Have the following tools: Flat Head Screwdriver, #2 Phillips Head Screwdriver and Hammer Caution: If using a power drill or power screwdriver for screwing, please be aware of to slow down and stop when screw is tight.
Board Identification Not actual size LEFT SIDE PANEL RIGHT SIDE PANEL Qty:1 Qty:1 Qty:1 BACK PANEL FIXED SHELF BACK PANEL Qty:1 Qty:1 Qty:1 BOTTOM FRONT RAIL REAR PULL BAR FRONT PULL BAR Qty:1 Qty:1 Qty:1 3/20...
Page 4
Board Identification Not actual size DRAWER FRONT DRAWER LEFT SIDE DRAWER RIGHT SIDE Qty:2 Qty:2 Qty:2 DRAWER BOTTOM DRAWER BACK PANEL Qty:2 Qty:2 4/20...
Page 5
Board Identification Not actual size 5/20...
Part List ∅ 6X35mm ∅ 6X30mm ∅ 4X35mm ∅ 15X9.5mm CAM LOCK CAM BOLT WOOD DOWEL SCREW spare : 2 spare : 2 spare : 2 spare : 1 ∅ 3X12mm ∅ 6X10mm 12" 12" SCREW SCREW LEFT CABINET MEMBER RIGHT CABINET MEMBER spare :...
Page 7
Part List 35mm ∅ ∅ 4X65(25) 3.5X14mm ∅ GROMMET LIGHT STRIP SNAP SCREW TOOL spare : 1 spare : 1 Cam Lock Fastening System Insert the cam bolt into the hole first, then insert the cam lock and lock it. The opening must point toward the edge of the board 7/20...
Page 8
STEP1 MODE SPEED DEMO SPEED COLOR MODE BRIGHT COLOR BRIGHT 6X30mm 3X12mm ∅ ∅ X1set FINISH The direction is consistent Before installing the strip, remove the protective film on the strip The No. 11 light strip is inclined into the No. 15 buckle first, and then press the other side with your hand to enter the buckle 8/20...
Page 18
STEP11 ∅ 3*14mm X4set Insert the plastic buckle into the back plate slot, screw through the hole in the plastic buckle and lock it in place. 18/20...
Page 20
RGB LED Controller Instrustions You can use the switch or remote to control the lighting effects. Description of switch function 1. Power on/off:Press and hold the power button. 2.Change the mode:Short press the cycle button.(Multiple mode options:Static Red/Static Green/Static Blue/Static White/Multicolor Blinking/Multicolor Breathing/Red Cycle Button Breathing/Blue Breathing/Green Breathing)