Click
, in the pop-up control window, and select the required parameters on the control
parameters:
Note: If the IDU does not support single attribute setting, "keep" cannot be selected for any
parameter. (Consult the technical staff about whether the specific model supports a single attribute)
Note: The control parameters displayed on the interface may exceed the actual controllable
parameters of the IDU. When this parameter is selected, the actual IDU does not operate.
1.7.2 Locking attribute
Select the IDU to be controlled (click to select, then click again to deselect), such as B102 IDU (the
blue box indicates that the IDU is selected):
22