Search (Topology) - Sinclair SDV6 SCC-61 User And Installation Manual

1.4 Search (Topology)

A device search is required to display the refrigerant systems connected to the centralized controller.
* The centralized controller must meet the requirements for the following two periods of time before
conducting "Device search"
Time 1: Time taken to wait for the VRF refrigerant system to run properly (about 15 minutes,
depending on the actual refrigerant system).
When the refrigerant system is powered on, system detection will take some time. During
this period, the centralized controller may obtain incorrect information about the refrigerant
system. If you conduct "Device search" at this moment, the information about the
refrigerant system obtained by the centralized controller will be incorrect (model
identification failure, improper set temperature range, and insufficient VRF units, etc.).
Time 2: time of communication between the centralized controller and VRFs (depending on the
number of connected refrigerant systems, about 5 minutes).
It takes more than 5 minutes for the centralized controller to connect with the properly
running VRF system. If you conduct a "Device search" before this, the information about
the refrigerant system obtained by the centralized controller will be abnormal (model
identification failure, improper set temperature range, and insufficient VRF units, etc.).
Steps: Power on the centralized controller 15 minutes after the communication cables are
connected and the VRF system is powered on. Wait 5 minutes, and search for the device.
Entry of the Settings interface (upper right corner)
Overview of device status: power-on, power-off,
disconnection, and failure, and statistics on the number of
devices; the list diagram shows general parameters.
Device monitoring: view device status (card form, list form),
managed groups, managed devices, control devices, etc.
Schedule management: View, edit, and modify schedules.
Report export
11