Table of Contents
Advertisement
Click the "Setting" function icon
shown in the figure below:
Click "Device search" in the left menu and "Auto topology" in the right area. The centralized controller
will start to obtain information about the refrigerant system connected to the centralized controller and
automatically construct the topological relationship. After this, the interface will appear as follows:
Parameter
Refri. system
Unit address
Unit type
Model
Unit name
Fan(W)
EH(W)
in the upper right corner to enter the "Setting" interface, as
Refrigerant system address, automatically generated after search, unmodifiable
Device address, automatically generated after search, unmodifiable
IDU: 00-63, ODU: 96-99 (master unit 96, slave units 1-3 correspond
to 97-99, respectively)
Device type (IDU or ODU), automatically generated after search, unmodifiable
Device model code, automatically generated after search, unmodifiable
For details about the mapping between models and codes, see "Model
Information" in the appendix.
Device name in the centralized controller, modifiable
The following names are displayed by default:
IDU: "IDU_Port_System_IDU Address"
ODU: "ODU_Port_System_ODU Address"
Power of IDU fan, modifiable
Power of IDU auxiliary heater, modifiable
Remarks
12
Advertisement
Table of Contents
