Advertisement
Installation instructions
Location
The T1 Terminator can be installed everywhere in a
non-hazardous area that complies with IP 20 (DIN 40
050) and the specified temperature range of -20 to
o
+60
Celsius.
Position
The T1 Terminator can be installed in every position,
but it is recommended to install it with the green
PROFIBUS connector pointing down. In this position
it is easier to read the status display and to perform
measurements on the DB9 connector.
Mounting and dismounting
The T1 Terminator has to be mounted on a 35 mm DIN-
rail with a minimum width of 60 mm. Fig. 1 and Fig. 2
illustrate how to mount and dismount the T1 on and
from the DIN-rail.
Advertisement
Related Manuals for HMS Networks Anybus Terminator T1
Related Products for HMS Networks Anybus Terminator T1
- HMS Networks Airconwithme
- HMS Networks Anybus Communicator
- HMS Networks Anybus Communicator ABC3028
- HMS Networks Anybus Communicator ABC3028-A
- HMS Networks Anybus Communicator ABC3261-A
- HMS Networks Anybus Communicator ABC4021
- HMS Networks Anybus Communicator ABC4023
- HMS Networks Anybus CompactCom 40 POWERLINK
- HMS Networks Anybus Defender Compact
- HMS Networks Anybus North ABC3213-A
- HMS Networks Anybus Wireless Bolt II
- HMS Networks Anybus Wireless Bolt LTE
- HMS Networks Anybus Wireless Bolt LTE AWB1502-B
- HMS Networks Anybus Wireless Bolt LTE AWB1503-B
- HMS Networks Anybus Wireless Bolt LTE AWB1504
- HMS Networks Anybus Wireless Bolt LTE AWB1505
Need help?
Do you have a question about the Anybus Terminator T1 and is the answer not in the manual?
Questions and answers