Network Stack Configuration - DFI ADN171 User Manual

Configure the serial settings of the current COM port.
Terminal Type
Select terminal type: VT100, VT100+, VT-UTF8 or ANSI.
Bits per second
Select serial port transmission speed: 9600, 19200, 38400, 57600 or 115200.
Data Bits
Select data bits: 7 bits or 8 bits.
Parity
Select parity bits: None, Even, Odd, Mark or Space.
Stop Bits
Select stop bits: 1 bit or 2 bits.
Flow Control
Select flow control type: None or Hardware RTS/CTS. Flow Control is for RS485 mode and is
only supported by Serial Port 1 (COM1).
User's Manual | ADN171_ADN173
Advanced
X

Network Stack Configuration

Network Stack
Enable or disable UEFI network stack. The following fields will appear when this field is
en-abled.
Ipv4 PXE Support
Enable or disable IPv4 PXE boot support. If disabled, IPv4 PXE boot support will not be
avail-able.
Ipv6 PXE Support
Enable or disable IPv6 PXE boot support. If disabled, IPv6 PXE boot support will not be
avail-able.
PXE boot wait time
Set the wait time in seconds to press ESC key to abort the PXE boot. Use either +/- or
numeric keys to set the value.
Media detect count
Set the number of times the presence of media will be checked. Use either +/- or numeric
keys to set the value.
Chapter 3
BIOS SETTINGS
38