Sony CCD-F35 Service Manual page 226

3-19. COASTER (LEFT) ASSEMBLY,
2)
)
4)
5)
6)
8)
i)
3
4)
5)
(Grease
DRIVE GEAR (LEFT) ASSEMBLY
Removal (See Fig. 3-20.)
Remove the DC motor (capstan motor) as described in
section 3-3.
Remove the timing belt (L), the RC gear assembly and the
loading lever assembly as described in section 3-15.
Remove the coaster (right) assembly and the drive gear
(right)assembly as described in section 3-18.
Remove the screw @, then remove the coaster plate spring
@ and the coaster (left) assembly @.
Remove the two screws @ , then remove the reinforcing
plate SS assembly @.
Remove the stopper washer 1.5 @, then remove the drive
gear (left) assembly @.
Installation (See Fig. 3-20.)
Grease the points of the mechanism chassis shown in Fig A.
Apply half a drop of oil to the axle @ (See Fig. E).
Grease pin @ , axle @ and dowel @ of the coaster (left)
assembly @ (See Fig. B).
Mount by aligning the pin @ and the axle @ with the slot @
of the mechanism chassis.
Fit the drive gear (left) assembly @ to the axle @ , and
mount so that the gear engages with the wheel gear ® and
the UL gear @.
6) Align the ® part with the slot @, and the hole @ with the
pin @ of the coaster (left) assembly @.
7) Install the stopper washer 1.5@.
the dowel ®, then tighten the two screws @ in the indicated
order.
10) Grease points indicated in Figs. C and D.
11) Mount the coaster (right) assembly and the drive gear
(right)assembly as described in section 3-18.
14) Mount the drum assembly as described in section 3-13.
Note: ¢ Screw @ should be tightened with a tightening torque
of approx. 500g*cm. If tightened too much, the coaster
(right) assembly © and the coaster plate spring @ will
be deformed.
¢ After installing,
be sure
to perform
tape path
adjustment as described in section 4.
(approx. 10 to 15 mm dia.
Grease
(approx. 10 mm dia.)
Fig. E
© Reinforcing Plate SS
@ Stopper
Washer 1.5
Wheel Gear
© Coaster (left) Assembly
Fig. 3-20.