Sony CCD-F35 Service Manual page 212

3-4. S BRAKE, T BRAKE
1. Removal (See Fig. 3-4.)
1) Remove the torsion coil spring (ST) @.
2) Remove the axle holding pin @ , then remove the T brake
S.
3) Remove the axle holding pin @ , then remove the S brake
4
5)
Installation (See Fig. 3-4.)
While fitting the toothed part @ into the notch @, mount the
S brake @.
Insert the axle holding pin @. y
Insest the axle @ to the S reel side of the brake release arm
@ so that the @ part comes closer to the drum than part @,
and mount the T brake @.
Insert the axle holding pin @.
Insert the torsion coil spring (ST) @ below the claw @ of
the axle @ , then hook it to two claws @.
Note: Confirm that the claws of axle holding pins @ and @ are
not broken before assembling.
© Axle Holding Pin
@ Torsion Coil Spring (ST)
@ Axle Holding Pin
© Brake Release Arm
Fig. 3-4.
—10—