Gooseneck Gear Assy - Sony DCR-PC350 Service Manual

3-16.Gooseneck Gear Assy

1. Removal procedure
1) Move the LS chassis block assy 1 in the direction of the arrow
A to make it in YJ position.
YJ position: The position B where gooseneck gear assy can
be removed. (where the center of LS chassis hole matches with
junction gear shaft.)
2) Remove the gooseneck gear assy, holding it with C.
1 LS chassis block
assy
GOOSENECK
GEAR ASSY
Points
to be noted
Hold the C
C portion
C
Shaft D
YJ Position
A
B The position where gooseneck gear assy can be removed.
2 Gooseneck gear assy
— 27 —
DV MECHANICAL ADJUSTMENT MANUAL VII
2. Attachment procedure
1) Apply grease to the gooseneck gear shaft D portion.
Amount of grease: a ball of grease of 1.0 mm diameter
Need no re-application to one which applied already.
2) Install the gooseneck gear assy, holding it with C in the
gooseneck gear shaft.
3) Move it closer to the S reel.
Mechanism chassis block assy
(Where the center of LS chassis hole matches with junction gear shaft.)
GOOSENECK GEAR ASSY
Points to be noted
Gooseneck gear shaft
Amount of grease: a ball of
grease of 1.0 mm diameter
Re-application of grease to
the point which is greased
already before is not necessary.
• Do not apply grease to the
wrong position.
• Do not forget to apply grease.
• Do not make mistake about amount of grease.
• When applying grease, do not splash or touch
grease to any other parts and components.
junction gear shaft
LS chassis hole
Key Points
in Re-assembling
S reel
After installation, move it closer to
the S reel side.
Apply Grease
Apply grease