Kenmore Elite 79041103100 Installation Instructions Manual page 10

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with Sealed Top Burners)
ECE Range Installation
Important Note: Door removal is not a requirement for
installation of the range, but is an added convenience.
Refer to the Use
and Care Guide for
oven door removal
instructions.
2 mon
Standard Installation Figure 10
PA The range cooktop overlaps the countertop at the
sides and the range rests on the floor. The cooktop
is 31 1/2" (81 cm) wide.
BP Ulnstall base cabinets 30" (76.2 cm) apart. Make
sure they are plumb and level before attaching
cooktop. Shave raised countertop edge to clear 31
1/2" (81 em) wide range top rim.
10.3 [Gell cabinet doors 31" (78.7 cm) min. apart so it
will not interfere with range door opening.
EQ Ticutout countertop exactly as shown on page 1.
For models equipped with Leveling Device:
El Make sure the front leveling legs and the rear
leveling device are setup higher than the height of
the cabinet.
(RS 7 YerielN) Install the anti-tip bracket at this
point before placing the range at its final
position. Follow the installation instructions on
page 14 or 15 or on the anti-tip bracket template
supplied with the range.
10.7 I provide an optimum installation, the top surface
of the countertop must be level and flat (lie on the
same plane} around the 3 sides that are adjacent
to range cooktop. Proper adjustments to make
the top flat should be made or gaps between the
countertop and the range cooktop may occur.
os Wei gis)s) To reduce the risk of damaging your
appliance, do not handle or manipulate it by the
cooktop or control console. Manipulate with care.
EEF Position range in front of the cabinet opening.
EW Make sure that the cooktop which overhangs the
countertop clears the countertop. If necessary,
raise the unit by lowering the leveling legs.
10.11 Site the range into the cutout opening and center
it before leveling it.
eePLevel the range (see section 11}. The floor where
the range is to be installed must be level. Follow
the instructions under "Leveling the Range- Models
Equipped with Leveling Device".
ER Adjust leveling legs so that the underside of the
cooktop is sitting on the countertop. Carefully
screw in (refer to Leveling the range: Models
equipped with Leveling Device") the back leveling
leg until the cooktop overhang touches slightly the
countertop. Then carefully screw in the front two
leveling legs until the cooktop overhang touches
slightly the countertop.
For models equipped with Leveling Leg only (no
leveling device):
El Make sure the four leveling legs (front and rear)
are setup higher than the height of the cabinet
(shown on page 3).
Install the anti-tip bracket at this
point before placing the range at its final
position. Follow the installation instructions on
page 14 or 15 or on the anti-tip bracket template
supplied with the range.
10.7 I provide an optimum installation, the top surface
of the countertop must be level and flat (lie on the
same plane} around the 3 sides that are adjacent
to range cooktop. Proper adjustments to make
the top flat should be made or gaps between the
countertop and the range cooktop may occur.
el 7 terarieyh| To reduce the risk of damaging your
appliance, do not handle or manipulate it by the
cooktop. Manipulate with care.
BEEF Position range in front of the cabinet opening.
Pe Make sure that the cooktop which overhangs the
countertop clears the countertop. If necessary,
raise the unit by lowering the leveling legs.
Uh Level the range (see section 11). The floor where
the range is to be installed must be level. Follow
the instructions under "Leveling the Range-Models
Equipped with Leveling Legs".
10.12 Sees the range into the cutout opening.
Dilger ie If Accessories Needed
installation With Backguard
A backguard kit can be ordered through a Sears
Service Center. The cutout depth (2134" (55,2cm) Min.,
22'/s" (56,2cm) Max.) needs to be increased to 24"
(6lcem) when installing a backguard
installation With End Panel
An end panel kit can be ordered through a Sears
Service Center.
installation With Side Panel
A side panels kit can be ordered through a Sears
Service Center. Install cabinet doors 31" (78,7cm) min.
apart so as not to interfere with range door opening.